LaMotte WaterLink SpinTouch 3580 Bedienungsanleitung Seite 7

recycling systems contact local or regional waste administration or recycling
services. Do not incinerate the equipment
DISK DISPOSAL
The disks cannot be reused. Over time, the water in
reacted disks will eva3porate. Disks can be recycled. Warning: Recyclers
should check with the local authorities. Some states may require that no chemical
residue remains on the plastic or may not be able to accept plastic waste with
stainless steel mixing beads. Used disks may be returned, at the customer's
expense, to LaMotte for recycling.
GENERAL INFORMATION
PACKAGING AND RETURNS
Experienced packaging personnel at LaMotte
Company assure adequate protection against normal hazards encountered
in transportation of shipments. After the product leaves the manufacturer, all
responsibility for its safe delivery is assured by the transportation company. Damage
claims must be filed immediately with the transportation company to receive
compensation for damaged goods. Should it be necessary to return the instrument,
pack the instrument carefully in a suitable container with adequate packing material.
A return authorization number must be obtained from LaMotte Company by calling
1-800-344-3100 or 1-410-778-3100, ext. 3 or emailing
lamotte.com. Attach a letter with the authorization number to the shipping carton
which describes the kind of trouble experienced.
GENERAL PRECAUTIONS
Read the instruction manual before attempting to set
up or use the instrument. Failure to do so could result in personal injury or damage
to the meter. The WaterLink Spin Touch should not be stored or used in a damp
or excessively corrosive environment. Care should be taken to prevent water or
reagents from entering the photometer chamber. Wet disks should never be put into
the photometer chamber.
SAFETY PRECAUTIONS
Read the safety precautions on the labels of all reagent
containers and packaging prior to use. Safety Data Sheets (SDS) can be found at
www.lamotte.com. Additional emergency information for all LaMotte reagents is
available 24 hours a day from the National Poison Control Center at 1-800-222-
1222 or by contacting the 24 hour emergency line for ChemTel at 1-800-255-3924
(USA, Canada, Puerto Rico). For locations outside of the North American continent
call 813-248-0585 collect.
Ensure that the protection provided by this equipment is not impaired. Do not install
or use this equipment in a manner that is not indicated in this manual.
LIMITS OF LIABILITY
Under no circumstances shall LaMotte Company be liable for
loss of life, property, profits, or other damages incurred through the use or misuse of
its products.
CE MARK
The WaterLink Spin Touch meter has been independently tested and has
earned the European CE Mark of compliance for electromagnetic compatibility and
safety. To view certificates, go to the LaMotte website at www.lamotte.com.
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment
is operated in a residential environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following
measures:
¬ Reorient or relocate the receiving antenna.
¬ Increase the separation between the equipment and receiver.
¬ Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
¬ Consult the dealer or an experienced radio/TV technician for help.
Disk ABD Patent No. 8.734.734
FCl ABD Patent No. 8.987.000
FCl AB Patent No. EP2784503 A1
TCl ABD Patent No. 8.993.337
NSF CERTIFICATION
and operating range. Certification levels of L1, L2, and L3 are possible with L1 being
the highest rating. Go to
For the most recent WaterLink Connect 2 update and the most recent Spin Touch
firmware update, customers who intend to use a WaterLink Spin Touch Meter for
NSF certification compliance purposes should:
1. Visit
2. Plug the Spin Touch into the computer using the included USB cable.
3. Open the WaterLink Connect 2 desktop application and wait for the update to
softwaresupport@
Test Factor
pH
Free Chlorine
Chlorine, Combined
Cyanuric Acid
Effective April 2022. Based on a 12 month shelf life. Other test factors not evaluated
by NSF.
Go to
supported, and a current listing of LaMotte NSF 50 certified products.
WARRANTY
in parts and workmanship for 2 years from the date of shipment. Keep the proof
of purchase for warranty verification. If it should become necessary to return the
instrument during or the warranty period, contact our Technical Service Department
at 1-800-344-3100 or 1-410-778-3100, ext. 3 or
for a return authorization number or visit
help. The sender is responsible for shipping charges, freight, insurance, and proper
packaging to prevent damage in transit. This warranty does not apply to defects
resulting from action of the user such as misuse, improper wiring, operation outside
of specification, improper maintenance or repair, or unauthorized modification.
LaMotte Company specifically disclaims any implied warranties or merchantability or
fitness for a specific purpose and will not be liable for any direct, indirect, incidental,
or consequential damages. LaMotte Company's total liability is limited to repair
or replacement of the product with a new or refurbished meter as determined by
LaMotte Company. The warranty set forth above is inclusive and no other warranty,
whether written or oral, is expressed or implied.
Water Testing Leader Since 1919
LaMotte, WaterLink, Spin Touch are ® registered trademarks of LaMotte Company
© 2023 LaMotte Company, All Rights Reserved.
7
The NSF/ANSI/CAN 50 certification mark on a water quality
testing device (WQTD) used in recreational waters, such as pools and spas,
means that the product was reviewed and certified by NSF International
to meet applicable American National Standards for product design
and performance. NSF tests and re-tests products to confirm that they
comply with all requirements of certification for performance, accuracy
www.nsf.org for more information.
softwarecenter.lamotte.com
application for Windows.
complete.
Application
Pool
Spa/Hot Tub
Pool
Spa/Hot Tub
Pool
Spa/Hot Tub
Pool
www.NSF.org to review the latest levels, ranges, shelf life, firmware versions
LaMotte Company warrants this instrument to be free of defects
and download the WaterLink Connect 2
NSF Level
NSF Certified Range Accuracy/Overall
6.4–8.6 L1
6.4–8.6 L1
0–15 ppm L1
0–7 ppm L1
0-1 ppm L2
0-1 ppm L2
5–50 ppm L1
softwaresupport@lamotte.com
www.lamotte.com for troubleshooting
05.02.2023
3580-MN-A4 | EN |
Certified to
NSF/ANSI/CAN 5 0