Seasonal Disuse; Disposal; Spare Parts - Checchi & Magli SP50 Bedienungsanleitung

22.0 - SEASONAL DISUSE

11.2 - The cardan shaft supplied is of standard length; check therefore that the
following conditions are met when the shaft is inserted:
At the end of the season, or in the event that a stoppage of more than one month is
A) Machine fully lowered
envisaged, it is advisable to proceed as follows:
Exceed the minimum extension by at least 4 cm (fig. 7) so as to absorb possible
22.1 - wash and dry the equipment, paying particular attention to removing residues
further contraction of the shaft.
of fertilizers or chemical products.
B) Machine fully raised
22.2 - check and if necessary, renew damaged or worn parts.
When the shaft is at maximum extension, the two tubes must overlap by at least 15
22.3 - grease thoroughly, store the equipment in a dry area and protect it with a
cm (fig. 8).
tarpaulin. Apply a thin layer of lubricant to the parts not protected by galvanization or
11.3 - Any modification of the length of the cardan shaft must also be made to the
paint.
protection devices, and must be carried out by skilled personnel.
22.4 - Position the equipment as indicated in point 12.0.
11.4 - Check that the angles of the transmission, when in the working position, do not
The advantages which derive from complying with the above recommendations are
exceed 20°.
exclusively of benefit to the user, who will then find the equipment in excellent condition
11.5 - The cardan shaft cannot be used in the following conditions:
when it is next required.
-without the protection devices;

23.0 - DISPOSAL

-with partial protection devices;
-with damaged protection devices;
The machine consists of ferrous metals.
-without the anti-rotation chains correctly fastened.
At the end of its working life it must be scrapped at an authorized waste disposal
11.6 - Warning: improper use of the cardan shaft may damage the transmission and
centre.
endanger the operator.

24.0 - SPARE PARTS

11.7 - If a cardan shaft not supplied by Checchi & Magli is used, it must be capable
Orders for spare parts must preferably be sent via an authorized dealer and
of transmitting at least the power shown in chapter 4.0 (fig. 1).
accompanied by the following information:
12.0 - UNCOUPLING FROM THE TRACTOR
24.1 - type, model and serial number shown on the affixed data plate (reference 1,
-position the equipment on the ground, only in a flat area;
page 26).
24.2 - code number and description taken from the spare parts catalogue.
-make certain that the equipment remains stable;
24.3 - quantity requested -remove fixing pins and plugs, taking care not to get between the equipment and the
24.4 - shipment is made according to the customer's requests; in the absence of any
tractor;
requests, it will be made by the means considered most suitable. -ensure again that everything is stable, bearing in mind all eventualities.
24.5 - the terms Left and Right are intended to indicate the left and right of the -remove the cardan shaft from the tractor side.
machine when viewed from behind.
13.0 - FUNCTIONS OF THE TRACTOR DRIVER
Pay particular attention to the safety regulations in point 8.
Be especially careful when turning and reversing, because in view of its size, the
machine could cause damage to property or injury to persons in its operating range.
max
20°
FIG. 7
SP50 SP50
SP100 SP100
max
20°
FIG. 8
37 33