Maintenance; Recommended Lubricants; Seasonal Disuse - Checchi & Magli WOLF Bedienungsanleitung

28.0 - MAINTENANCE

The maintenance intervals listed below are guidelines for conditions of normal use.
In the case of more demanding working conditions due to environment or seasonal
factors, the frequency of maintenance operations must be increased accordingly.
Always carry out maintenance operations in accordance with the safety
regulations set out in point 8.0.
28.1 - CLEANING THE DRILLING CUPS
Constantly check that the drilling cups are clean (fig. 33.A) and that they close correctly.
Should this not be the case, remove any excess soil or peat that may have
accumulated on the inside and on the outside of the cups and in particular in the
area shown in fig. 32.B.
28.2 - EVERY 40 HOURS OF WORK
- Grease the drilling cup (fig. 33.C)
- Oil the moving parts of the semi-cups (fig. 33.D)
- Oil the transmission chains (fig. 34.A and 34.B)
- Check that the screws are tight.

28.3 - RECOMMENDED LUBRICANTS

Grease and oil can be used in the same way as for the tractor, in accordance with
the warnings and precautions appearing on the relative containers.

29.0 - SEASONAL DISUSE

At the end of the season, or in the event that a stoppage of more than one month is
envisaged, it is advisable to proceed as follows:
29.1 - wash and dry the equipment, paying particular attention to removing residues
of fertilizers or chemical products.
29.2 - check and if necessary, renew damaged or worn parts.
29.3 - grease thoroughly, store the equipment in a dry area and protect it with a tarpaulin.
Apply a thin layer of lubricant to the parts not protected by galvanization or paint.
29.4 - Position the equipment as indicated in point 8.0.
The advantages which derive from complying with the above recommendations are
exclusively of benefit to the user, who will then find the equipment in excellent condition
when it is next required.
C
C
D
B
WOLF
WOLF-COMPACT
C
A
FIG. 33
65