Coupling To The Tractor; Cardan Shaft - Checchi & Magli SP50 Bedienungsanleitung

10.0 - COUPLING TO THE TRACTOR

10.1 - The machine must be coupled to the tractor on flat ground.
10.2 - Check that the three-point linkages are of a compatible category.
10.3 - Bring the tractor up to the machine, taking care not to get between the two at
this stage, and proceed with coupling only when the tractor is stationary. Fix the three
coupling arms with the relative pins and insert the appropriate safety split pins (fig. 4).
10.4 - Limit sideways movements and keep the machine parallel with the tractor,
using the stabilizer chains and arm adjustment device (fig. 5).
10.5 - Adjust the third point arm until the machine coupling is at right angles (fig. 6).

11.0 - CARDAN SHAFT

Insert the cardan shaft only when the engine is OFF and the machine is positioned
on the ground, and fasten the anti-rotation chains on both sides.
11.1 - The cardan shaft supplied by the manufacturer Checchi & Magli conforms with
the relevant EC legislation and has its own use and maintenance manual.
11.2 - La transmission à cardans fournies est de longueur standard. Par conséquent,
32
FIG. 6
FIG. 4
SP50
SP100
FIG. 5