Adjusting The Automatic Safety Release Function; Adjusting The Float Skid; Adjusting The Planting Force (Load Applied To Ground) - Checchi & Magli WOLF Bedienungs- Und Wartungsanleitung

Adjusting the automatic safety release function

UN41 0083GF
The automatic release is designed to protect the trans-
mission components from overloads (e.g. if the dispens-
er or ejector jams).
The device is already set by the manufacturer during the
testing stage, but can be adjusted by the user according
to requirements.

Adjusting the float skid

UN41 0464BM
Proceed as outlined below.
1) Loosen the screw (A).
2) Raise or lower the float skid.
English language
ADJUSTMENT INFORMATION
For adjustments, proceed as outlined below.
1) Turn the ring nut (A) clockwise to increase the release
resistance (i.e. less sensitive).
Turn the ring nut (A) anticlockwise to decrease the
release resistance (i.e. more sensitive).
A
3) Tighten the screw (A).
4) Adjust the load applied to the ground (see "Adjusting
the planting force" - page 17).
19
5
Use and maintenance