Automatic Switch-Off; Anti-Drip System - Silvercrest SDBB 2400 A1 Bedienungsanleitung

Automatic switch-off
This steam iron is fitted with an automatic switch-off system. This stops the steam
iron from heating up if it is not moved within a certain amount of time:
■ If the iron is resting on its soleplate
onds, you will hear a warning beep and the control lamp for the automatic
switch-off
up. To deactivate the automatic switch-off, lift up the steam iron and move it
gently from side to side. The steam iron will heat up again.
■ If the iron is on its base
hear a warning beep and the control lamp for the automatic switch-off
starts flashing. The steam iron will automatically stop heating up. To deacti-
vate the automatic switch-off, lift up the steam iron and move it gently from
side to side. The steam iron will heat up again.
NOTE
► The automatic switch-off is not intended as a substitute for removing the
plug from the mains power! It is merely intended to reduce the fire hazard if
you forget to switch off the steam iron.

Anti-drip system

The steam iron has an anti-drip system that automatically switches off the steam
blast at low temperatures. If this happens, you will hear a click. You must then set
a suitable temperature with the temperature control
ture is reached, steam production is resumed.
NOTE
► Wait until the set temperature has been reached and the control lamp
lights up before pressing the steam blast button
water may drip from the soleplate
SDBB 2400 A1
7
starts flashing. The steam iron will automatically stop heating
9
and is not moved for about 8 minutes, you will
0
and is not moved for about 30 sec-
6
. As soon as this tempera-
4
again. Otherwise,
0
.
7
7
GB │ IE │
11 ■