Automatic Switch-Off; Cleaning; Self-Cleaning Function; Housing And Sole Of The Iron - Silvercrest SDBS 2800 A1 Bedienungsanleitung

Automatic switch-off
This steam iron is fitted with an automatic switch-off
system. This stops the iron from heating up.
If the iron is resting on its sole
for about 30 seconds, there will be a warning
beep and the AUTO OFF control lamp
The iron will stop heating up. To deactivate the au-
tomatic switch-off, lift up the iron and move it gently
from side to side. The AUTO OFF control lamp
goes out and the iron will heat up again.
If the iron is on its base
about 1 minute, there will be a warning beep and
the AUTO OFF control lamp
will stop heating up. To deactivate the automatic
switch-off, lift up the iron and move it gently from
side to side. The AUTO OFF control lamp
out and the iron will heat up again.
NOTE
The automatic switch-off is not intended as a
substitute for removing the plug from the mains
power! This is merely intended to reduce the fire
hazard if you forget to switch off the iron!

Cleaning

Self-cleaning function

■ Fill the water tank to the "MAX" marking.
■ Insert the plug into the mains power socket.
■ Move the temperature control
position.
■ Use the steam quantity button
level 3.
■ Allow the steam iron to heat up until the control
lamp "LINEN" lights up permanently.
■ Hold the steam iron horizontally over a suitable
container.
NOTE
If your hands are sensitive to heat, wear oven
gloves. Hot steam escapes during cleaning.
SDBS 2800 A1
and is not moved
flashes.
and is not moved for
flashes. The iron
goes
to the "MAX"
to select steam
■ Press the self-clean button
pressed. Move the steam iron back and forth a
little.
Steam and boiling water will flow from the
steam exit holes in the sole of the iron
impurities and limescale that may be present are
flushed out.
■ Release the self-clean button
of the water in the water tank is used up.
■ Dry the sole of the iron
this, move the sole of the iron
several times over a towel or an old piece of
material.
■ Allow the steam iron to cool down before putting
it away.

Housing and sole of the iron

MORTAL DANGER!
► Always remove the plug before cleaning the
appliance. There is a risk of electric shock!
RISK OF INJURY!
► Allow the appliance to cool down before
cleaning it. Otherwise, there is a risk of burns!
CAUTION! PROPERTY DAMAGE!
► Do not use aggressive, abrasive or chemi-
cal cleaning agents. They can damage the
surface and also lead to irreparable damage
to the appliance.
■ Clean the housing with a soft, dry cloth only.
■ Clean the sole of the iron
and a mild, non-scouring detergent.
■ Dry the appliance well before using it again.

Storage

Store the cooled-down appliance in a clean, dust-
free and dry location.
and keep it
. Any
as soon as all
thoroughly. To do
back and forth
using a damp cloth
21 ■
GB│IE
│