Drain The Fuel; Commissioning; Working Instructions; Starting The Engine - Parkside PBBPS 700 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

9.4 Filling in fuel (Fig. 8)
m WARNING
Only fill the fuel when the engine is switched off and has
cooled down. There is a risk of fire!
1. Always clean the area around the fuel tank cap (13) be-
fore filling to prevent dirt from falling into the fuel tank.
Use a dry, lint-free cloth for this purpose.
2. Lay the device on its side with the fuel tank cap (13)
facing upwards.
3. Turn the fuel tank cap (13) anti-clockwise and open it.
The fuel tank cap (13) is connected to an anti-loss device
in the fuel tank and thus cannot fall off.
4. Pour the fuel mixture into the fuel tank. Do not spill fuel
when refuelling and do not fill the fuel tank to the brim.
5. Wipe up spilled fuel immediately.
6. Turn the fuel tank cap (13) clockwise to close it.
NOTE
Also check the chain oil after each fuel fill.
9.5

Drain the fuel

Only empty the fuel tank outdoors or in well-
ventilated rooms. Make sure that no fuel gets
into the soil (environmental protection). Use a
suitable and stable base.
1. Hold a collection container under the fuel tank.
2. Unscrew and remove the fuel tank cover (13) of the fuel
tank.
3. Drain the petrol/oil mixture completely.
4. Screw the fuel tank cover (13) back on by hand.
9.6 Fill in chain oil (Fig. 8)
m WARNING
Only fill the saw chain oil when the engine is switched off and
has cooled down. There is a risk of fire!
Never work without chain lubrication! If the saw chain (1)
runs dry, the cutting gear will be irreparably destroyed in a
short time.
Always check chain lubrication before working.
NOTE
Use only saw chain oil. Preferably biodegradable. Do not use
waste oil, engine oil, etc.
Check during work that the chain lubrication is working.
1. Always clean the area around the chain oil tank cap
(11) before filling so that no dirt falls into the chain oil
tank. Use a dry, lint-free cloth for this purpose.
2. Lay the device on its side with the chain oil tank cap (11)
is facing upwards.
3. Turn the chain oil tank cap (11) anti-clockwise and open
it. The chain oil tank cap (11) is connected to an anti-loss
device in the chain oil tank and thus cannot fall off.
4. Pour the bio chain oil into the chain oil tank. Do not spill
chain oil when refuelling and do not fill the chain oil
tank to the brim.
5. Wipe up spilled chain oil immediately.
6. Turn the chain oil tank cap (11) clockwise to close it.

10. Commissioning

m CAUTION
Please observe the legal provisions from the noise protection
ordinance.
Before each commissioning, check the device for the follow-
ing:
• Check the fuel system for leakage
• Faultless condition and completeness of the guards and
the cutting device
• Tight fit of all screw connections
• Smooth running of all moving parts

Working instructions

Familiarise yourself with handling the chainsaw before use.

10.1 Starting the engine

m ATTENTION
Move at least 3 metres away from the refuelling area before
starting the engine (Fig. 9).
Always pull the start pull cord (8) out straight. Hold the han-
dle of the start pull cord (8) firmly when the pull cord (8)
winds back in. Never let the start pull cord (8) whip back in.
Release the throttle lever (5) immediately after starting the
engine. Ensure that the engine speed has returned to idle be-
fore releasing the chain brake (push the front hand guard (3)
backwards).
Pull out the cold start lever (choke) (14) only for starting.
GB 111