Mettler Toledo IND131 Installationshandbuch Seite 36

IND131/IND331 Terminals Installation Manual
B. Loosen and remove the two nuts securing the two grounding straps (that
C. Carefully rotate the front cover 180 degrees and reattach the two
4. Mark the position of the mounting holes on the vertical surface per the
dimensions shown in Figure 2-22.
2-12
also operate as hinges for the front cover) to the rear housing. See Figure
2-20.
Remove nuts
and ground
straps from
these bolts
Figure 2-20: Loosening the Ground Straps
grounding straps to the two studs near the grip bushings using the two
nuts removed in the previous step as shown in Figure 2-21. Tighten the
two nuts.
Figure 2-21: Reversing the Cover
When cover is
reversed, straps
attach to these
bolts
Video/keyboard
harness