Mettler Toledo IND131 Installationshandbuch Seite 35

Figure 2-18: IND331 Rubber Feet
Harsh Enclosure Wall Mounting
There is an optional wall mounting bracket kit available for wall mounting the
harsh enclosure to a vertical surface. To wall mount the enclosure, follow these
steps:
1. Bolt the two brackets to the bottom of the enclosure using the four M5 screws
included with the terminal. The brackets should be attached as shown in
Figure 2-19.
Figure 2-19: Attaching the Wall-Mounting Brackets
2. If the enclosure will be mounted above eye level, proceed to step 4.
3. If the enclosure will be mounted at or below eye level, it will be necessary to
reverse the front cover 180 degrees. To reverse the front cover, perform the
following steps:
A. Open the enclosure per the instructions provided in the Opening the
Enclosures section.
IND131/IND331 Terminals Installation Manual
2-11