KNF LABOPORT SC820G Originalbetriebsanleitung Seite 154

Setup and connection
Connected com-
ponents
46
Fig.7: Connecting the signal cable
Ensure that the signal cable is correctly aligned with the
separator (30° angle; see Fig. 7).
2. Remove the protective caps from the pneumatic connec-
tions of the vacuum system (see 1 and 8 or 1 and 7).
3. Connect the lines to the pneumatic inlet and outlet.
Only connect components to the vacuum system that are
designed for the pneumatic data of the vacuum system
(see Chapter 5 Technical data [} 25]).
Translation of Originial Operating Instruction, KNF 339416-339418 02/23
Vacuum system SC820G / SC840G