Introduction; Device Description (Fig. A - O); Scope Of Delivery - Scheppach 5910114903 Originalbetriebsanleitung

2. Introduction

Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
we hope your new tool brings you much enjoyment
and success.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by
the product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non-original spare
parts,
• Application other than specified.
We recommend:
Read through the complete text in the operating in-
structions before installing and commissioning the
device.
The operating instructions are intended to help the
user to become familiar with the machine and take
advantage of its application possibilities in accord-
ance with the recommendations.
The operating instructions contain important informa-
tion on how to operate the machine safely, profes-
sionally and economically, how to avoid danger, cost-
ly repairs, reduce downtimes and how to increase
reliability and service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regu-
lations that apply for the operation of the machine in
your country.
Keep the operating instructions package with the
machine at all times and store it in a plastic cover to
protect it from dirt and moisture. Read the instruction
manual each time before operating the machine and
carefully follow its information.
The machine can only be operated by persons who
were instructed concerning the operation of the ma-
chine and who are informed about the associated
dangers. The minimum age requirement must be
complied with.
In addition to the safety instructions contained in this
operating manual and the specific regulations of your
country, the technical rules generally accepted for the
operation of machines of the same type must be ob-
served.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.

3. Device description (fig. A - O)

1. Front hand guard
2. Front handle
3. Air filter cover
4. Starter pull cord
5. Cap for the air filter cover
6. On/Off switch
7. Fuel pump (primer)
8. Cold start lever (choke)
9. Throttle control lock
10. Throttle control
11. Rear handle
12. Rear hand guard
13. Fuel tank cap
14. Chain oil tank cap
15. Spiked bumper (pre-assembled)
16. Guide rail (pre-assembled)
17. Saw chain (pre-assembled)
18. Grinder support
19. Oil adjusting screw
20. Locking nut
21. Chain-tensioner screw
22. Sprocket cover
23. Chain tensioner pin
24. Chain catcher
25. Hole for the chain tensioner pin
26. Chain sprocket
27. Guide rail cover
28. Screwdriver
29. Allen key, 3mm
30. Mixing container
31. Spark plug wrench/flat-blade screwdriver
32. Round saw chain file
33. Air filter
34. Spark plug connector
35. Felling marks
36. Air filter screw

4. Scope of delivery

• 1 chain saw (pre-assembled)
• 1 spark plug wrench/flat-blade screwdriver
• 1 cover for the guide rail (chain guard)
• 1 mixing container
• 1 Screwdriver
• 1 Allen key, 3mm
• 1 Round saw chain file
• 1 set of operating instructions
www.scheppach.com
GB | 29