Cameo OTOS B5 Bedienungsanleitung Seite 31

When replacing the lamp, wear protective glasses and protective gloves!
When carrying out any work, make sure that no foreign bodies enter the housing!
The UV filter for protection against UV radiation is located directly in front of the
lamp. Take care not to damage the UV filter! The UV filter must not be removed and a
damaged UV filter must be replaced immediately! Operation without UV protection or
damaged UV protection is prohibited! There is an immediate risk of injury if the device
is put into operation with a missing or damaged UV filter!
In order to maintain the seal of the OTOS B5 moving head according to protection
class IP65, a new seal must be inserted at the appropriate location after the lamp has
been replaced. Carefully follow each step in the instructions below.
1. Fully disconnect the spotlight from the mains (pull out the mains plug)! Make sure that the
spotlight has cooled down completely!
2. Lock the spotlight head to prevent unintentional twisting (pan and tilt locking).
3. Loosen the 4 Allen screws of the rear head cover (see markings), remove the cover from the
spotlight head, release the safety cable of the cover and place it to one side.
4. Loosen the 4 Allen screws holding the fan unit to the spotlight head (see markings) and hang
them carefully on the safety cable. Ensure that the supply lines are not damaged.
3
4
31