Cameo OTOS B5 Bedienungsanleitung Seite 14

ATTENTION: In order to provide protection from spraying water, in accordance with
protection class IP65, special IP65-rated XLR connectors must be used correctly with the
DMX input and output sockets, or they must be closed using the rubber sealing caps.
When connected correctly, or when sealed correctly with the rubber sealing caps, the
POWER IN and POWER OUT sockets are protected from spraying water, as in accordance
with IP65.
OTOS B5
7 LC-DISPLAY
The illuminated display shows the currently activated mode (main display), the menu items in the
main menu and sub-menus and the numerical value or status in certain menu items. If there is no
control signal to the device, the characters in the centre of the display start flashing; the flashing
stops as soon as a control signal is available (W-DMX, DMX and slave operation).
8 TOUCH-SENSITIVE CONTROLS
MENU – Press MENU to access the main menu. Press again or repeatedly to return to the main
display.
UP and DOWN – Select the menu items in the main menu (DMX address, operating mode, etc.) and in
the sub-menus using UP and DOWN. Change the status or value in a menu item, e.g. DMX address.
ENTER – Press ENTER to access the menu level to make value or status changes, and to access
one of the sub-menus. Confirm value or status changes by pressing ENTER.
LOCK
14
7
®
9
Mechanical locking device used to prevent the rotation
9
of the head in the horizontal direction during transport.
UNLOCK
Disconnect the unit from the mains, move the head parallel
to the base (4 possible positions) and push the locking lever
in the direction of the pan rotation axis (LOCK) to lock it in
position. Unlock the device before startup (UNLOCK).
UP
8
MENU ENTER
DOWN
PAN LOCK