Cameo OTOS B5 Bedienungsanleitung Seite 23

This will take you to the submenu for setting the submenu items (see table, select with UP and
DOWN, confirm with ENTER, change value or status with UP and DOWN, confirm with ENTER). The
settings for each loop are made separately and are retained even after restarting the device.
Edit Loop
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
SLAVE OPERATION
Standard slave operation: Starting from the main display, press MENU to enter the main menu.
Use UP and DOWN to select the menu item Control and confirm with ENTER. Then select Slave
and confirm again. Now select Group and then the slave group 0 (Group 00). Confirm by pressing
ENTER again. Activate the output of the control signal in the master unit (Control -> Stand Alone
-> Master/Alone -> Master). Connect the slave and master units (same model, same software
version) using a DMX cable or make the connection via W-DMX and activate the stand-alone
mode User Scene or Play Loop in the master unit. The slave unit will now follow the master unit.
Slave
Group Set slave group for signal delay
XLR (permanently active)
Receive
mode
Wireless
User Scene 1 - User Scene 8
t-Step 0s - 20min
t-Fade 0s - 20min
User Scene 1 - User Scene 8 +
Skip Step
t-Step 0s - 20min
t-Fade 0s - 20min
Activate W-DMX module
Deactivate W-DMX module
Disconnect all connections and place in pairing standby mode
User scene selection
Sets step time
Sets fade time
"
User scene selection + skip
step
Sets step time
Sets fade time
"
"
"
"
"
"
"
"
"
"
"
00 - 24
On
Off
Unlink
23