Cameo OTOS B5 Bedienungsanleitung Seite 21

STAND ALONE OPERATION PLAY LOOP
Eight loops, pre-programmed at the factory but individually editable, are available in the control
menu (Loop 1 - 8). Each loop consists of up to eight scenes, which in turn can be edited
individually (Scene 1 - 8). Starting from the main display, press MENU to enter the main menu.
Use UP and DOWN to select the control menu Control and confirm with ENTER. Now select the
menu item Stand Alone, confirm, select Play Loop, confirm, then select the desired loop and
confirm again. The selected loop is activated when confirmed.
MASTER / ALONE USER SCENE & PLAY LOOP
In stand-alone mode User Scene and Play Loop, the control signal of the scenes and loops can
be output to slave units via XLR (DMX OUT) and W-DMX (Control -> Stand Alone -> Master/Alone
-> Master). To delay the control signal for slave units, set the delay time from 0 to 2 seconds
(see also SLAVE OPERATION). If the output of the control signal is not desired, the output can be
deactivated (Control -> Stand Alone -> Master/Alone -> Alone). Starting from the main display,
press MENU to enter the main menu. Use UP and DOWN to select the control menu Control and
confirm with ENTER. Now select the menu item Stand Alone, confirm, select Master/Alone and
confirm again.
21