Cameo OTOS B5 Bedienungsanleitung Seite 24

Extended slave operation: The control signal can be played back with a time delay in up to
24 steps. Activate the output of the control signal in the master unit (Control -> Stand Alone ->
Master/Alone -> Master) and set the delay in the submenu item Delay. Set the delay factor in
the slave menu of the corresponding slave unit (Control -> Slave -> Group 00 - 24). Activate the
desired loop in the master unit (Loop 1 - Loop 8). Now the slave unit follows the master unit with
a time delay according to the settings in the menu of the master and the slave unit.
SYSTEM SETTINGS (Settings)
From the main display, press MENU to enter the Main Menu. Select Settings using UP and DOWN
and confirm with ENTER.
Information on the submenu items in the Settings menu and the corresponding setting options
can be found in the table below (select with UP and DOWN, confirm with ENTER, change value or
status with UP and DOWN, confirm with ENTER).
Settings
State
Lamp
Default
Power Mode
24
On Switching on the lamp
Switch off the illuminant ⓘ ATTENTION!
Switching off the lamp shortly after
switching on is prevented by a delay
Off circuit to protect the lamp (approx. 1
minute)! Do not disconnect the device
from the power supply before the
switch-off process is complete!
On Lamp switched on after restart
Off Lamp switched off after restart
Status before switching off is restored
Last
after restart
Standard
Maximum brightness
(480W)
Eco Reduced maximum brightness in the event
(380W) of reduced fan speed