Cameo OTOS B5 Bedienungsanleitung Seite 11

CAUTION! Switching off the lamp shortly after switching on is prevented by a delay
circuit to protect the lamp (approx. 1 minute)! Do not disconnect the device from the
power supply before the switch-off process is complete!
LAMP
In order to keep the device in perfect working order, it is recommended that the lamp
is replaced after 1,500 hours of operation, at the latest, by qualified service person-
nel. When replacing lamps, use only the model specified in the data sheet!
Conditions
Rated output power
Max. service life*
The service life of the lamp is influenced by the number of times it is switched on.
It is recommended to run the lamp for at least 15 minutes after switch-on to com-
plete the chemical cycle of the lamp and increase its life.
*Definition of service life: The time at which 50% of the lamps are still in operation
and deliver at least 50% of the original light output.
CAUTION! POTENTIAL DAMAGE FROM EXTERNAL LIGHT SOURCES!
Sunlight, laser radiation and focused light beams from other spotlights can damage
the housing and internal components such as filters, gobo and colour wheels, motors,
cables, belts, etc., as well as light sources! Do not expose the fixture and especially
the lens aperture to direct sunlight, laser radiation and focused light beams from
other spotlights during unpacking, installation, prolonged non-use and operation!
Always point the lens opening towards the floor when the unit is not in use! For
this purpose, also use the Sun Protection function, which can be activated via DMX
command (see Device Settings channel in the DMX table). An integrated gyroscope
sensor detects the position of use. Damage caused by external light sources is
excluded from the manufacturer's warranty!
Operating time
1500 h
3000 h
11