Cameo OTOS B5 Bedienungsanleitung Seite 19

DMX OPERATION VIA W-DMX
Starting from the main display, press MENU to enter the main menu. Use UP and DOWN to select
the control menu Control and confirm with ENTER. Wählen Sie nun den Menüpunkt W-DMX aus
und bestätigen abermals.
See the table below for information on the sub-menu items in the W-DMX menu and the relevant
setting options.
W-DMX
DMX address 001 - 4xx
17CH Basic
DMX mode 19CH Standard
23CH Extended
Off
Receive On
Unlink
Send to XLR
Signal routing Backup by XLR Control via XLR (DMX IN) with W-DMX signal interruption
Receive only
STAND ALONE OPERATION USER SCENE
Stand-alone operation User Scene allows, similar to using a DMX controller, to adjust Pan, Tilt,
Gobo, Pan / Tilt macros etc. directly on the fixture with values from 000 to 255. Eight scenes
are available (Scene 1 - 8). The scenes are pre-programmed ex works, but they can be edited
individually. Starting from the main display, press MENU to enter the main menu. Use UP and
DOWN to select the control menu Control and confirm with ENTER. Now select User Scene,
confirm, select the desired scene and confirm again.
Setting the DMX start address
Selecting the DMX mode
Deactivate reception via W-DMX
Activate reception via W-DMX
Disconnect all connections and place in pairing standby mode
Forwarding the control signal to XLR (DMX OUT)
No connection between W-DMX signal and XLR connectors
19