Operation; Information On Sawing; Inserting And Removing The Battery; Switching On And Off - Parkside PSTDA 20-Li B3 Originalbetriebsanleitung

Operation

Information on sawing

General Information
With this order, you work safely with the sabre
saw and achieve a good result:
1. Clamp the workpiece. Use a clamping
device for small workpieces.
2. Draw a line to specify the direction in which
the saw blade is guided.
3. Hold the device securely by the handle.
4. Set the stroke rate.
5. Set the mitre angle.
6. Set the stroke strength.
7. Turn the device on.
8. Wait until the device has reached its full
stroke rate.
9. Place the footplate on the workpiece.
10. Slowly move the device along the marked
line, pressing the footplate firmly down onto
the workpiece.
11. Do not apply too much pressure in the cut-
ting direction. Let the device do the work.
12. Before shutting down the device, switch it
off and wait for it to come to a complete
standstill.
Selecting the pendulum motion
The larger the pendulum motion, the faster your
progress.
The optimal pendulum motion can be estab-
lished through practice; the following settings
are recommended:
• For thin material, hard material (e.g. steel)
or for cutting curves: Level 0
• Fine and clean cutting edges can be
achieved with little or no pendulum motion:
(level 1 or 0).
• Soft material (wood, plastic, etc.): level 2 or
3
0 1
Material
Hard (steel)
thin
Cut edges
Clean
Cut direction
2 3
Soft (wood, plastic)
thick
Rough
0 1
Curved
Plunge sawing
Requirements
• Soft materials such as wood, aerated con-
crete, plasterboard etc.
• Mitre angle: 0°
• Short saw blade mounted
Procedure (Fig. F)
1. Place the device with the front edge of the
footplate (11) on the workpiece. The saw
blade (16) does not touch the workpiece.
2. Turn the device on. Wait until the maximum
stroke rate has been reached.
3. Press the saw blade (16) into the workpiece
until the footplate (11) rests on the work-
piece.
4. Continue sawing along the cutting line.
Inserting and removing the
battery
WARNING! Risk of injury due to uninten-
tional start-up. Only insert the rechargeable
battery into the device once the device is fully
prepared for use.
NOTICE! Risk of damage! An incorrect battery
can damage the device and battery.
Inserting the battery (Fig. G)
1. Push the battery (28) along the guide into
the battery holder (4).
✔ You will hear the battery click into place.
Removing the battery (Fig. G)
1. Press and hold the battery release (30) on
the battery (28).
2. Pull the battery out of the battery holder
(4).

Switching on and off

Switching on
You can regulate the stroke rate continuously
with the on/off switch. The more you press the
on/off switch, the higher the stroke rate.
1. Insert the rechargeable battery (28) into
the device.
2. Press the switch lock (1).
GB
2 3
Straight
29