Safety Information; Charging Time - Parkside PSTDA 20-Li B3 Originalbetriebsanleitung

GB
Bevel cutting
...................−45°; −22.5°; 0°; 15°; 30°; 45°
Sound pressure level (L
Sound power level (L
WA
– Measured ...................... 96.2 dB; K
Vibration (a )
h
– Wood .......................9.27 m/s²; K=1.5 m/s²
– Metal ..................... 12.67 m/s²; K=1.5 m/s²
Temperature ........................................... ≤50 °C
– Charging ....................................... 4 – 40 °C
– Operation .................................−20 – 50 °C
– Storage ..........................................0 – 45 °C
Lidl Smart battery Smart PAPS 204 A1/
Smart PAPS 208 A1
– frequency band ............ 2400–2483.5 MHz
– transmitted power ........................... ≤ 20 dBm
Levels of noise and vibration were determined
according to the standards and regulations in
the declaration of conformity.
The specified total vibration value and the
stated noise emission value have been meas-
ured according to a standardised test method
and can be used to compare one power tool
with another. The specified total vibration value
and the stated specified noise emission value
can also be used for a provisional assessment
of the load.

Charging time

(min.)
PLG 20 A1
PLG 20 A4
PLG 20 C1
PLG 20 A2
PLG 20 A3
PLG 20 C3
PDSLG 20 A1
Smart
PLGS 2012 A1

Safety information

This section deals with the basic safety instruc-
tions for using the device.
22
) . 85.2 dB; K =5 dB
pA pA
)
=5 dB
WA
PAP 20 A1
PAP 20 B1 PAP 20 A2
60
45
35
35
35
WARNING! The vibration and noise emis-
sions may deviate from the specified values
during actual use of the power tool, depend-
ing on how the power tool is being used. Try to
keep the exposure to vibrations as low as pos-
sible. An example of a measure to reduce vi-
bration exposure is limiting the working hours.
All parts of the operating cycle have to be con-
sidered while doing so (for example, times
when the power tool is switched off and times
when it is switched on but running without any
load).
Charging time
The device is part of the X 20 V TEAM
series and can be operated with batteries of
the X 20 V TEAM series. Batteries of the
X 20 V TEAM series may only be charged
using chargers of the X 20 V TEAM series.
We recommend that you operate this ap-
pliance with the following batteries only:
PAP 20 B1, PAP 20 B3, Smart PAPS 204 A1,
Smart PAPS 208 A1
We recommend charging these batteries
with the following chargers: PLG 20 A3,
PLG 20 A4, PLG 20 C1, PLG 20 C3,
PDSLG 20 A1, Smart PLGS 2012 A1
Rechargeable battery and charger technical
data: See separate manual.
PAP 20 A3
PAP 20 B3
Smart PAPS 204 A1
90 120
60 80
45 60
45 60
40 40
WARNING! Injury and property dam-
age due to improper handling of battery. Ob-
serve the safety information and notes on char-
ging and proper use as shown in the instruction
manual for your battery and charger from the
Smart
PAPS 208 A1
210
165
120
120
50