Connecting The Controller; Function Test - Kärcher 2.644-371.0 Bedienungsanleitung

Socket
1
3. Cut out the film over the switch socket.
Control panel
1
Side brush switch
2
4. Latch the switch for the side brush into the control panel.
5. Plug in the free connector at the switch.
6. Reinstall the control panel.
7. Screw in the screw (7x).

Connecting the controller

Side brush motor, left: Lifting module 2, slot X6
1
Side brush motor, right: Lifting module 1, slot X6
2
Lifting motor of side brushes: Lifting module 2, slot X5
1
Ground point
1
1. Connect the cables of the positive terminal and side brush to
the connections.
Connect red to red and white to white.
2. Connect the cable of the lifting motor to the connection.
3. Connect the two cables of the side brush (negative terminal)
to the ground point.
Activating the attachment kit
Note
The red KIK is required for activating the attachment kit.
1. Fit the red KIK.
2. Press the Info button.
3. Select the "Attachment kits" menu.
4. Turn to the attachment kit "Side brush" with the Info button.
5. Press the Info button and activate the attachment kit "Side
brush".
1. Connect the battery.
2. Switch the device on.
3. Press the "Side brush" button on the control panel.
4. Check the function of "Side brush".
PRÉCAUTION
Dégâts matériels dus à un montage mal effectué
Confier le montage à un spécialiste qualifié pour ce faire.
Pour des raisons de sécurité et de garantie, le montage doit être
effectué par le service Kärcher.
Remarque
Respecter également le mode d'emploi et les consignes de sécu-
rité de l'appareil dans lequel le kit de montage est installé.
Français

Function test

Description
9