EINHELL FREELEXO CAM Originalbetriebsanleitung Seite 61

Alarm LED (57)
Lit yellow
Lit red
Flashing red
Anl_FREELEXO_CAM_SPK13.indb 61 Anl_FREELEXO_CAM_SPK13.indb 61
GB
Description / possible cause
Wheel fault:
- The rear wheels (8) were
lifted by an obstacle
- The rear wheels (8) can rota-
te freely due to unevenness
in the lawn
„STOP" button fault:
The control panel cover (13) is
open and a button on the con-
trol panel (2) was pressed but
the „STOP" button (3) was not
activated
Outside:
The robot lawn mower cannot
recognize any lawn area or
lawn boundaries and lies out-
side the mowing area.
Sensor fault:
- The robot lawn mower was
stopped due to a sensor fault
Motor fault / motor overcur-
rent:
- The robot lawn mower has
come to a stop because of
overcurrent in the motor or
because of a motor fault
Operating fault:
- The robot lawn mower was
stopped due to an operating
fault
Magnetic tape fault:
The robot lawn mower does not
receive a signal from the mag-
netic tape sensor.
- 61 -
Solution
Press the „STOP" button (3) in order to open
the control panel cover (13). Re-start the mo-
wing operation on the control panel (2):
- Move the robot lawn mower to a level area
and restart
Press the „STOP" button (3) in order to open
the control panel cover (13). Re-start the mo-
wing operation on the control panel (2):
- Check if the control panel cover (13) can
be freely opened and closed with the
„STOP" button (3).
- Check the functionality of the „STOP" but-
ton (3).
Press the „STOP" button (3) in order to open
the control panel cover (13). Re-start the mo-
wing operation on the control panel (2):
- Check that the robot lawn mower is inside
the mowing area.
Switch off the main switch (7) (OFF) and
then switch it back on (ON) again to restart
the robot lawn mower.
Switch off the main switch (7) (OFF) and
then switch it back on (ON) again to restart
the robot lawn mower.
- Check the height of the grass in the
mowing area and, if necessary, mow the
grass to below 60 mm using a conventio-
nal lawn mower.
- Increase the cutting height. Always start
with a higher cutting height and reduce it
in small steps until you reach the desired
height.
- Inspect the blade plates (11) and wheels
for dirt and give these parts a thorough
clean.
- Check the rear wheels and the blade plate
(11) for blockages. If you are unable to
remove the blockages, contact the res-
ponsible customer service center.
Switch off the main switch (7) (OFF) and
then switch it back on (ON) again to restart
the robot lawn mower.
Switch off the main switch (7) (OFF) and
then switch it back on (ON) again to restart
the robot lawn mower.
01.12.2022 15:35:26 01.12.2022 15:35:26