Filling the salt reservoir
Before filling the salt reservoir for the
first time, you must fill it with approx.
2 l of water to enable the salt to dis-
solve.
Once the dishwasher has been used
once, there is always sufficient water
in the salt reservoir.
Remove the lower basket from the
wash cabinet and unscrew the salt
reservoir cap.
Fill the salt reservoir with approx. 2 l
of water (first use only).
Place the funnel provided over the
salt reservoir and carefully fill with
dishwasher salt until the reservoir is
full. The salt reservoir holds up to
2 kg of salt, depending on the type of
salt used.
Clean off salt residues from around
the salt reservoir opening. Next,
screw the salt reservoir cap on again
firmly.
Only use special coarse grained reactiv-
ation salt with granules of approx. 1 -
4 mm. Do not use other types of salt
en - Before using for the first time
such as cooking salt, agricultural grade
or gritting salt. These may contain insol-
uble additives which can impair the
functioning of the water softener. If in
doubt consult the Miele Professional
Department.
47