Starting The Programme; End Of Programme - Miele PFD 104 SCVi Marine Kurzgebrauchsanweisung

en - Operation
For each programme sequence, the
control module calculates the pro-
gramme running time according to the
temperature of the incoming water and
the amount of crockery.

Starting the programme

 Start the programme by closing the
door.
Confirm the previously displayed
messages with OK.
The in-operation indicator light comes
on to show that a programme sequence
has been started.
During a programme sequence, you
can use OK to display the name of the
programme that is currently running
while the door is open.

Risk of scalding due to hot wa-
ter.
During operation, water in the dish-
washer may be very hot.
During operation, only open the door
with extreme caution.
52

End of programme

At the end of a programme, the in-oper-
ation indicator light will flash slowly with
the door shut. The buzzer might also
sound.
The in-operation indicator light will go
out 10 minutes after the end of the pro-
gramme if the door is closed.
The programme has ended when the
display shows the message 
In some programmes, if the "AutoOpen"
function is activated, the door will auto-
matically open slightly. This improves
the drying process.
If the Consumption
tion is activated, you can now view the
actual water consumption of the pro-
gramme which has just finished.
The drying fan may continue to run for
a few minutes at the end of the pro-
gramme.

Risk of damage due to steam.
Steam from the dishwasher could
damage the edges of worktops when
you open the door at the end of the
programme if the fan is no longer
running.
If you have deactivated the auto-
matic door opening function but
would still like to open the door at
the end of the programme, then
make sure that you open the door
fully.
Finished
programmable func-
.