GB
IE
the LED work light, now press and hold the
transparent On/off switch for several secon-
ds. The LED work light switches off, but the
device continues running.
To only switch off the LED work
light, make sure to press and hold
the On/off switch for several se-
conds. Pressing for too short of a
time switches off the entire device.
Switching the device off:
Hold down the transparent On/off switch
(
1) for 0.2 seconds
A
Place the cordless hot glue
gun on the inserted batte-
ry until the device is cooled
down completely. The hot
nozzle can cause damage
and/or burns.
The device has an automatic
switch-off when the device is not
in use. It switches off automatically
after 30 minutes.
Operating temperature
indicator
After switching on the device, it heats up.
The transparent On/off switch (
up:
On/off switch (
= device heating up
On/off switch (
= operating temperature reached
(approx. 140°C)
The device takes approx. 60 se-
conds to heat up before it reaches
the operating temperature.
22
1) lights
A
1) lit up red
A
1) lit up green
A
Working with the device
Preparing the bonding surfaces
Do not use any flammable
solvents to clean the bonding
surfaces.
•
Clean the bonding surfaces! They must
be clean, dry and free of grease.
•
Roughen smooth surfaces before glu-
ing.
•
Warm quick-cooling materials such as
steel up a bit before gluing. The glue
will stick better.
•
The ambient temperature and the ma-
terials to be glued must not be colder
than + 5°C or warmer than + 50°C.
Gluing
•
Press the trigger (7) to regulate the glue
flow rate. If you are no longer able to
move the glue stick (2) forward with
the trigger (7), just insert a new glue
stick (2).
Inserted glue sticks remain in the gun
until they are used up completely.
•
Press the trigger (
glue flow rate.
•
Apply the glue in spots. On flexible
materials, such as textiles, it makes
sense to apply the glue in zigzag lines.
•
Press the materials to be glued together
for approximately 30 seconds after
applying the glue. The bond is able to
withstand stress after about 5 minutes.
•
When taking a break, place the hot
cordless hot glue gun on the inserted
battery. Make sure to place the hot
nozzle far enough away from objects
or people to avoid damage or burns.
•
After cooling, remove any adhesive
residues using a sharp knife. The bon-
7) to regulate the
A