Analyzing The Connection Quality In Infrastructure Mode - Sirona CEREC 3 Installationsanleitung

Sirona Dental Systems GmbH
Installation instructions for WLAN card LINKSYS WMP54GS CEREC 3 Acquisition Unit
Performing the communication test
Performing the communication test
61 90 602 D 3344
D 3344.092.16.01.02 09.2007
If the connection is intact, the display should have the following
contents.
6. Close the DOS prompt window.
6.2 Analyzing the connection quality in
Infrastructure Mode
Analyzing the WLAN connection quality is essential for the optimal wireless
operation of the CEREC system. Merely observing the WLAN signal strength
using appropriate software tools is not enough to provide information
concerning the connection quality. In particular, the utilization of the set
WLAN channel is critical here.
The occurrence of weak communications despite good signal strength points
to an overloaded WLAN channel.
Switch off the PC, access point and the milling unit.
1. Position the PC near the access point (1-2 m away).
2. Switch the PC, access point and the milling unit on.
CAUTION: Use only the test
The service software is intended as a resource for the service engineer.
Without service engineer training, you should use only the described test for
serial communication.
6 Connection test and analysis
"Serial communication"
17