Connection Test And Analysis; Connection Test Via Ping Command - Sirona CEREC 3 Installationsanleitung

6 Connection test and analysis

Connection test via ping command

16
Installation instructions for WLAN card LINKSYS WMP54GS CEREC 3 Acquisition Unit
6
Connection test and analysis
6.1 Connection test via ping command
Click "Start" / "Run" in the task bar.
1.
Fig. 6-1 DOS prompt
Enter "cmd" in the following window.
2.
Confirm with "OK".
3.
The DOS prompt window then opens.
CAUTION: The IP address is only an example
The IP address in the next screenshot is only an example.
The IP address of the milling unit appears on the milling unit display when,
after turning the unit on, you press the "Config" key.
Enter the command "ping", followed by a space and the IP address of
4.
the milling unit.
Fig. 6-2 Example ping command
5. Press the Enter key.
Sirona Dental Systems GmbH
61 90 602 D 3344
D 3344.092.16.01.02 09.2007