Installing The Wlan Card In The Acquisition Unit - Sirona CEREC 3 Installationsanleitung

4 Installing the WLAN card in the acquisition unit

Opening the PC
Opening the PC
Installing the WLAN card
Closing the PC
Fastening the antenna
10
Installation instructions for WLAN card LINKSYS WMP54GS CEREC 3 Acquisition Unit
4
Installing the WLAN card in the
acquisition unit
All programs have been terminated and the PC has been shut down
(Start/Shutdown).
1. Switch off the acquisition unit.
2. Unplug the acquisition unit from the power supply.
3. Remove the PC and open its housing.
4. Remove the lowest PCI slot plate.
Insert the WLAN card A and lock it into the slot.
1. Close the PC and affix the technical service seal included in the scope of
supply.
2. Connect the supplied antenna cable to the WLAN card.
3. Put the PC back in place.
1. Adhere the supplied antenna bracket to position B and C on the inside of
the rear panel.
2. Connect the antenna cable to the antenna and attach it as shown in the
picture.
CAUTION: Do not pinch any cables!
Pay attention to the cable routing when inserting the rear panel.
3. Insert the rear panel.
4. Connect the acquisition unit to the power supply.
5. Switch the acquisition unit on.
Sirona Dental Systems GmbH
61 90 602 D 3344
D 3344.092.16.01.02 09.2007