Beko BBCW13400X Benutzerhandbuch Seite 6

• The product must not be
plugged into the outlet during
installation, repair, and trans-
portation.
• Plug the product into an outlet
that meets the voltage and fre-
quency values specified on the
type label.
• If your product does not have
a power cable, only use the
power cable described in the
"Technical specifications" sec-
tion.
• Do not jam the power cable
under and behind the product.
Do not put a heavy object on
the power cable. The power
cable should not be bent,
crushed, and come into con-
tact with any heat source.
• The rear surface of the oven
gets hot when it is in use.
Power cords must not touch
the back surface, connections
may be damaged.
• Do not jam the electric cables
into the oven door and do not
pass them over hot surfaces.
Otherwise, cable insulation
may melt and cause fire as a
result of short circuit.
• Use original cable only. Do not
use cut or damaged cables or
intermediate cables.
• If the power cable is dam-
aged, it must be replaced by
the manufacturer, an author-
ized service or a person to be
specified by the importer com-
pany in order to prevent pos-
sible dangers.
• WARNING: Before replacing
the oven lamp, be sure to dis-
connect the product from the
mains supply to avoid the risk
of electric shock. Unplug the
product or turn off the fuse
from the fuse box.
If your product has a power
cable and plug:
• Do not plug the product into
an outlet that is loose, has
come out of its socket, is
broken, dirty, oily, with risk of
water contact (for example,
water that may leak from the
counter).
• Never touch the plug with wet
hands! Never unplug by pulling
on the cable, always pull out
by holding the plug.
• Make sure that the product
plug is securely plugged into
the outlet to avoid arcing.
EN / 6