Information; Unit Settings Menu; Operating Structure For Unit Settings - Aerex Rls T1 Sys Montage- Und Betriebsanleitung

7 Unit settings menu

Information

6.1.1 Display
Parameters: Language
Setting value: currently: German
Parameters: Date/time
Setting value: Hours/minutes/day/month/year
Parameters: Key lock (configuration only pos-
sible in installer level)
Setting value: No/Yes
Parameters: Change key lock code (between 4
and 8 digits are possible)
Setting value: Factory settings: 0000
Parameters: Activate/deactivate key lock now
Setting value: Key lock is activated immediately.
Deactivation of key lock via system settings/dis-
play/deactivate key lock now and PIN input.
Parameters: Display – standby time
Setting value: Minute settings of between 1 and
10 minutes. Factory settings: 5 minutes.
Parameters: Display – brightness
Setting value: Setting for brightness of between
0 and 100 %.
6.1.2 Time programme
The time program is programmed at the unit level.
More information Ventilation time programme
[} 30].
Parameters: Copy regular time programme
throughout system.
Setting value: Time settings can be transferred
from one unit to other units.
Parameters: Copy holiday time programme
throughout system.
Setting value: Time settings can be transferred
from one unit to other units.
Parameters: Start date for holiday time pro-
gramme
Setting value: applies to all units connected to
the control panel.
Parameters: End date for holiday time pro-
gramme
Setting value: applies to all units connected to
the control panel.
6.1.3 System
Parameters: Number of ventilation systems
Setting value: Number of ventilation systems to
be set (max. up to 10 ventilation systems). The
ventilation systems are addressed via the com-
missioning software. The addresses can only be
configured once in the bus system. Example: 6
ventilation systems, control panel setting: Number
of ventilation systems = 6, addressing of ventila-
tion systems: Address 1, Address 2, Address 3,
Address 4, Address 5, Address 6.
Parameters: Configuration of ventilation systems
Current ventilation systems visible with unit
status. Ventilation systems, which cannot be ac-
cessed via bus communication, are displayed
with the 'Not available' status. The ventilation sys-
tems can also be designated and ventilation sys-
tems assigned to a group in the configuration.
The group should be activated for this purpose.
Parameters: Group ventilation systems
Setting value: No/Yes
The ventilation systems can be split into up to 5
groups. Splitting the individual ventilation systems
into groups means that they can be controlled in
groups.
Parameters: Designation of groups
Designation of groups using text.
6.1.4 Installer
Parameters: Enter service code.
Switch to installer level. Allows the ventilation sys-
tem and individual ventilation systems to be con-
figured and the key lock to be activated. PIN
entry: 6940
Parameters: QR code
Link to instructions
6.1.5 Software version
Parameters: Software version of control unit.
Parameters: Software version of control
Software version of ventilation system currently
selected.
Parameters: Serial number of ventilation system
6.1.6 Error memory
Display showing fault messages/errors.
6.1.7 Information
Display showing potential notes about filter
changes or the operating status.
7 Unit settings menu
7.1 Operating structure for unit set-
tings
Basic settings
25