Herunterladen Inhalt Inhalt Diese Seite drucken

Measuring Blood Pressure - Beurer SR BM 2 Gebrauchsanweisung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
Set alarm
You can set 2 different alarm times to remind yourself to
take the measurement. To set the alarm, proceed as follows:
• Press and hold the function buttons - and + simultane-
ously for 5 seconds.
• Alarm 1
is shown in the display, „on" or „off" flashes
at the same time. With the function buttons -/+, choose
whether alarm 1 should be activated („on" flashes) or
deactivated („off" flashes) and confirm with the setting
button SET.
• If alarm 1
is deactivated („off"), you automatically
switch to setting alarm 2
• If alarm 1
is activated, the hours flash on the display.
Select the desired hour using the function buttons -/+ and
confirm with SET. The minutes flash on the display. Select
the desired minute using the function buttons -/+ and
confirm with SET.
• Alarm 2
is shown in the display, „on" or „off" flashes
at the same time. To set, proceed as for alarm 1
blood pressure monitor switches itself off automatically.
Operation with the mains adapter
You can also operate this device with a mains adapter.
When doing so, there must not be any batteries in the bat-
tery compartment.
.
. The
• To prevent possible damage to the device, the blood
pressure monitor must only be used with the mains
adapter described here.
• Insert the mains adapter into the connection provided for
this purpose on the blood pressure monitor. The mains
adapter must only be connected to the mains voltage that
is specified on the type plate.
• Then insert the mains plug of the mains adapter into the
mains socket.
• After using the blood pressure monitor, unplug the mains
adapter from the mains socket first and then disconnect it
from the blood pressure monitor. As soon as you unplug
the mains adapter, the blood pressure monitor loses the
date and time setting but the saved measurements are
retained.

5. Measuring blood pressure

Ensure the device is at room temperature before measuring.
The measurement can be performed on the left or right wrist.
Attaching the cuff
Place the cuff onto the bare upper
arm. The circulation of the arm
must not be hindered by tight
clothing or similar.
27

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis