Setting The Alarm; Select The User Memory; Measuring Blood Pressure - Beurer BM 95 Gebrauchsanweisung

6. The set year appears on the display again. To complete the operation, press the START/STOP
button . The device then switches off.

4.3 Setting the alarm

An optional alarm can be set on the device. To set the alarm, proceed as follows:
1. Press and hold the - button on the side for 5 seconds. "oFF" flashes on the dis-
play if the alarm is deactivated.
" " flashes on the display if the alarm is active.
Activate or deactivate the alarm using the +/- buttons. Press the memory but-
ton M to confirm the selection.
2. The alarm hour flashes on the display when the alarm has been activated. Set the alarm hour using
the +/- buttons. To confirm the alarm hour, press the memory button M.
3. The alarm minute now flashes on the display. Set the alarm minute using the +/- buttons. To con-
firm the alarm minute, press the memory button M.
4. " " appears on the display. To complete the operation, press the START/STOP button
The device then switches off.

4.4 Select the user memory

The device has two user memories. Each user memory can store up to 60 measured values. Once
all memory spaces in a user memory have been used, the oldest measured values are replaced by
the most recent.
• Briefly press the memory button M. The last set user is displayed. Press and hold the memory
button M for 5 seconds to switch between the user memories.

5. Measuring blood pressure

Before commencing blood pressure measurement, observe the "Notes on using the blood pressure
monitor" in chapter "2. Important notes".
46
.