Measuring Blood Pressure - Beurer BM 27 Gebrauchsanweisung

Pb = Battery contains lead,
Cd = Battery contains cadmium,
Hg = Battery contains mercury
Setting the hour format, date and time
It is essential to set the date and time. Otherwise, you will
not be able to save your measured values correctly with a
date and time and access them again later.
There are two different ways to access the menu from
which you can adjust the settings:
• Before initial use and after each time you replace the
battery:
When inserting batteries into the device, you will be
taken to the relevant menu automatically.
• If the batteries have already been inserted:
Press and hold the settings button SET on the device
when switched off for approx. 5 seconds.
To set the date and time, proceed as follows:
• Select 12h or 24h mode using the function buttons -/+.
Press SET to confirm. The year display will start to flash. Set
the year with the function buttons -/+ and confirm with SET.
• Set the month, day, hour and minute and confirm each
with the setting button SET.
• The blood pressure monitor switches itself off automatically.

5. Measuring blood pressure

Ensure the device is at room temperature before measuring.
The measurement can be performed on the left or right arm.
Attaching the cuff
Place the cuff onto the bare upper
arm. The circulation of the arm
must not be hindered by tight
clothing or similar.
The cuff must be placed on the
upper arm so that the bottom edge
is positioned 2 – 3 cm above the
elbow and over the artery. The line
should point to the centre of the
palm.
24