Engage The Manoeuvring System - Truma Mover XT Gebrauchsanweisung

Operation
No other remote control function must be active (slide
control / control knob must be in the centre position)
when the remote control is switched on�
Fig. 14
Slide the slide switch on the side upwards (Fig. 14)�
After switch-on, the
bar for approx� 5 seconds� Then the
lights up continuously and the manoeuvring system
is ready for operation�
5.3

Engage the manoeuvring system


CAUTION
Personal injury due to the caravan rolling
away
If the parking brake is released during the enga-
gement, the caravan can roll away in an uncont-
rolled manner�
Only release the caravan's parking brake
when the drive rollers on both sides are com-
pletely engaged�
The drive rollers are engaged on the caravan wheels by
means of the remote control�
Fig. 15
To engage the drive units, press and hold both the
ENGAGE buttons
An acoustic signal sounds and engagement of the
drive rollers starts after a 3 second safety delay�
The ENGAGE buttons
The symbol flashes in the toolbar during the
engagement�
If the engagement is complete, two acoustic signals
sound and the
toolbar�
The drive commands with the control knob and slide
control are executed only when the drive rollers are
completely engaged� If the engagement is interrupted,
it must be restarted and performed in full� Drive com-
mands can only be executed afterwards�
36 EN
symbol flashes in the tool-
symbol
at the same time (Fig. 15)�
can be released�
symbol disappears from the
If the two DISENGAGE buttons
the engagement, the engagement is immediately inter-
rupted and the disengagement is started�
Before the engagement
Fig. 16
During the engagement
Fig. 17
Engagement successful
Fig. 18
To check that the engagement has been successful:
The drive rollers are pressed approx� 20 mm into the
•
tyres on both sides�
The number 3 must be shown on the position indica-
•
tor on the manoeuvring system�
Mover XT XT2
are pressed during
Mover
Mover
60020-00204 ∙ 00 ∙ 08/2022