Coupling To The Towing Vehicle - Truma Mover XT Gebrauchsanweisung

Operation
Fig. 22
Caravan moves backwards (away from the drawbar)
Fig. 23
Control knob and slide control
The more the control knob is turned, the smaller the
turning radius�
Operating the control knob and the slide control causes
the manoeuvring system to go round in a circle, where-
by the wheels rotate continuously, but the inner wheels
rotate more slowly than the outer wheels�
Due to the design, it is not possible to manoeuvre in ve-
ry tight bends with a two-axle chassis�
Forward (turning right):
Fig. 24
Forward (turning left):
38 EN
Fig. 25
Reverse (turning right):
Fig. 26
Reverse (turning left):
Fig. 27
 Radio equipment or other remote controls will not
activate your manoeuvring system�
After manoeuvring, apply the parking brake and/or
secure the caravan with chocks to prevent it from
rolling away first of all, then deactivate the mano-
euvring system�
5.5

Coupling to the towing vehicle

The manoeuvring system allows a caravan to be coup-
led to a towing vehicle accurately and without jolting�
However, this requires care and a degree of practice�
Move the towing vehicle close to the caravan�
Secure the towing vehicle against rolling away ac-
cording to the operating instructions�
In order to position the caravan precisely, operate
the control knob or slide control until the caravan's
coupling is located directly above the ball coupling
on the towing vehicle�
Mover XT XT2
60020-00204 ∙ 00 ∙ 08/2022