Remote Control - Truma Mover XT Gebrauchsanweisung

Mover XT XT2
Body-mounted batteries (caravans with self-sufficient
power supply with correspondingly large capacity; see
table below) are also suitable�
Batteries
NOTICE
Malfunctions during operation due to incor-
rect power source
To guarantee proper operation of the mano-
euvring system, it may only be operated with a
charged battery (≥ 12 V)�
Operation with a charger as power source is
not possible and prohibited�
Recommended battery capacities
The 12 V battery used must be certified in accordance
with the national standards and regulations of the coun-
try of use and in accordance with the manufacturer's in-
stallation instructions� The battery must be dimensioned
in accordance with the technical requirements of the
manoeuvring system�
Starter batteries are not suitable�
Batteries with greater capacity allow the manoeuvring
system to be used for longer�
Round cell
technology
Mano- Capacity in Ah
euvring
system
XT 38
XT2 38
Charger
For optimum battery charging, we recommend the Tru-
ma BC 10 charger (a component of the PowerSet BC),
which is suitable for all battery types up to 200 Ah�
Fig. 6
4.5

Remote control

4.5.1 The remote control's functions
NOTICE
Damage to the remote control due to mois-
ture or heat
If moisture gets into the remote control or it is
exposed to strong sunlight for too long, this can
damage the remote control�
Protect the remote control from moisture�
Protect the remote control from strong
sunlight�
If there are other devices that work on the same fre-
quency (e�g� wireless garage doors, video surveillance
60020-00204 ∙ 00 ∙ 08/2022
Gel / Lead-acid battery
AGM (liquid electrolyte)
48 75
48 75
cameras, baby monitors, etc�) nearby, the manoeuvring
system comes to an imediate standstill for safety re-
asons if radio frequency interference occurs� It is im-
possible for other radio signals to set the manoeuvring
system in motion�
Fig. 7
ON / OFF
Switch on / switch off (slide switch on the
side)
SLIDE CONTROL
Drive forward and in reverse
CONTROL KNOB
Drive to the left (in an anti-clockwise di-
rection) and to the right (in a clockwise
direction)
ENGAGE
Drive rollers engaged
DISENGAGE
Drive rollers disengaged
4.5.2 The remote control's symbols and acoustic
signals
Symbol Colour Meaning
Red Warning – power supply / Mover
battery's charging status
Yellow Short-term malfunction or
warning
Red Continuous fault
Green Radio connection status
Sym- Display
bol
Switch on and normal operation
Product description
Meaning
EN 31