Replacing Remote Control Batteries - Truma Mover XT Gebrauchsanweisung

Mover XT XT2
Sym- Display
bol
Flashing with
acoustic signal
Flashes with
acoustic signals
Sym- Display
bol
What to do if the battery is weak or if overcurrent /
overtemperature / other malfunctions occur
Lights up
Light up if sym-
bols appear
Lights up con-
tinuously with
acoustic signal
XT-Reihe
All symbols "off" and no acoustic signal
60020-00204 ∙ 00 ∙ 08/2022
Meaning
The 13-pole safety plug
was pulled out while the
remote control was swit-
ched on�
Warning: The drive rollers
were engaged during this
process�
Switch the control unit
back on again by plugging
in the safety plug, switch
the remote control off and
back on again, disenga-
ge the drive rollers and
switch off normally�
The 13-pole safety plug
was pulled out while the
remote control was swit-
ched on�
The drive rollers were di-
sengaged during this pro-
cess� The remote control
switches off after a short
time� Move the remote
control's slide switch into
the OFF position�
Meaning
lights up in the event of
a temporary malfunction,
and an acoustic signal is
also emitted in the event
of overcurrent / overtem-
perature� The power is au-
tomatically reduced� Allow
the system to cool down�
The battery charge is low,
the remote control swit-
ches off after one minute
with acoustic signals�
Charge the battery, re-
place it if necessary after
checking it
lights up in the event of
a persistent fault, and an
acoustic signal is also
emitted, e�g� in the event
of a faulty drive motor,
engage the parking bra-
ke� See the Malfunctions
chapter
Manoeuvring system off (check batteries in remote
control if necessary)

4.5.3 Replacing remote control batteries

NOTICE
Damage to the remote control due to lea-
king batteries
Leaking batteries can damage the remote con-
trol� Then, the manoeuvring system can no lon-
ger be used�
Use leak-proof batteries�
If the remote control is not being used for an
extended period of time, remove the batte-
ries from the remote control�
Different types of batteries or new and used batte-
ries must not be used together�
Flat batteries must be removed from the remote
control and disposed of safely�
Only use leak-proof micro-batteries with a steel ou-
ter casing, type LR 03, AAA, AM 4, MN 2400 (1�5 V)�
 When inserting new batteries, take care not to rever-
se the positive and negative terminals�
Fig. 8
Open the battery cover
Remove used batteries and insert new ones (pay at-
tention to the positive and negative terminals)
Close the battery cover again
 No warranty is given for damage caused by leaking
batteries�
4.5.4 The remote control's automatic switch-off
The remote control switches itself off automatically
after approx� 3 minutes if none of the buttons are
pressed�
To reactivate the remote control, move the slide
switch on the side to "Off" and then back to "On"
after approximately 4 seconds�
 There is no "On / Off" switch on the caravan itself�
4.5.5 Switching off the remote control (emergen-
cy stop)
 The side slide switch on the remote control (On / Off)
also acts as an "Emergency Stop switch"�
Product description
EN 33