Removing The Side Panels; Preliminary Controls - SWM SIX DAYS Bedienungsanleitung

REMOVING THE SIDE PANELS

For some maintenance operations, one or both the
side panels need to be removed.
To remove the left-and right-hand side panels,
operate as follows:
- Unscrew the screw (2).
- Lift the panel (1) releasing it from the upper hooks
2

PRELIMINARY CONTROLS

A. Engine - transmission oil level
Note
Check the oil level when the engine has just been
turned off and is still hot.
- Position the motorcycle on a flat surface in vertical
position.
- Remove the RH side panel as described in the
relative paragraph.
- Unscrew the dip stick (1) and remove it; clean it
with a cloth and reinsert it in the filling hole (2)
without screwing it back in, then remove it again
and check that the oil level is between the "MIN"
and "MAX" notches
- If you need to top up, pour in oil through the hole
(2) until reaching the correct level.
- Reinsert the dipstick and screw it back into place.
1
SIX DAYS
1
1
2
7 -
EN