Removing The Side Panel; Preliminary Controls - SWM OUTLAW Kurzanleitung

REMOVING THE SIDE PANELS
For some maintenance operations, one or both the
side panels need to be removed.
To remove the left- and right-hand side panels, op-
erate as follows:
- Unscrew the screw (1).
- Lift out the panel (2) by unhooking it from the top
hooks.
For refitting, operate in reverse order from removal.
1
EN - 6

PRELIMINARY CONTROLS

A. Engine-transmission oil level
Note*: Check the oil level when the engine has just
been turned off and is still hot.
- Position the motorcycle on a flat surface in vertical
position.
- Remove the RH side panel as described in the rela-
tive paragraph.
- Unscrew the dipstick (1) and remove it; clean it
with a cloth and reinsert it in the filling hole (2)
2
without screwing it back in, then remove it again
and check that the oil level is between the "MIN"
and "MAX" notches.
- If you need to top up, pour in oil through the hole
(2) until reaching the correct level.
- Reinsert the dipstick and screw it back into place.
1
MAX
MIN
2
1