Inspection And Maintenance - Optimum Opti mill MH 35G Betriebsanleitung

5.2

Inspection and maintenance

The type and level of wear depends to a large extent on the individual usage and operating
conditions. Any indicated intervals therefore are only valid for the corresponding approved con-
ditions.
Interval Where?
Start of work,
after every main-
tenance or repair
work
Start of work,
after every main-
tenance or repair
work
Every week
Monthly
Monthly
Version 1.1.0 - 2021-02-09
What? How?
 
Safety check on page 67

Oil all guide rails.
Oiling

Oil all bare steel surfaces. Use acid-free oil.
Oiling

Ensure that the clamping bolts for swivelling the drill head
are firmly tightened.
firmly tight-
ened

Lubricate all oiler cups with machine oil, do not use grease
guns or the like.
Oiling
Translation of original instruction
MH35G│MH35V EN
93