Swivelling The Milling Head - Optimum Opti mill MH 35G Betriebsanleitung

4.14

Swivelling the milling head

The milling head can be swivelled to the right and to the left.

Loosen 3 fastening screws on the milling head.

Turn the drill-mill head clockwise to the desired position.

Retighten the fastening screws.
INFORMATION
The milling head should be aligned after resetting to the initial position with a dial indicator so
that holes can be produced with the spindle sleeve at a right angle. Set the zero degree angle
step using your set-up.
ATTENTION!
The drill-mill continues significantly further and also swivels in a different direction. By
continuing to swivel, gear oil may seep from the ventilation hole.
Version 1.1.0 - 2021-02-09
A
Clamping bolts
Translation of original instruction
B
MH35G│MH35V EN
91