Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Always your fingers behind the finger guards on the test leads when
using the probes.
4. Before test, make sure that the meter's fuse is good.
1. Refer to the Figure above and the section of identifying Test Leads,
insert the plug of the high-voltage test lead into MΩ jack, then insert
the plug of the test lead which has a big test clip into mA jack.
2. The test lead form mA jack is a ground line. The test lead form MΩ
jack is a live line. Set the range switch to OFF position, then
connect the big test clip to the test point of the object to be
measured.
3. Choose desired rated voltage:
To choose the desired rated voltage, set the range switch to
corresponding voltage position (4000MΩ/250V, 4000MΩ/500V or
4000MΩ/1000V.)
1.
Test lead with a big test clip
2.
High-Voltage test lead
-37-
Werbung
