Disengage The Manoeuvring System Manually (Emergency Disengagement) - Truma Mover XT L Gebrauchsanweisung

Operation
The position indicator shows how far the drive rollers
are engaged or disengaged:
Fig. 29
1-2 Engagement incomplete
Drive rollers completely engaged
3
No number
Drive rollers completely disengaged
visible
Fig. 30
To check that the disengagement has been successful:
In the disengaged position, the drive rollers are ap-
•
prox� 20 mm away from the tyres (Fig. 30) on both
sides� See Kapitel 6�1 to check the correct gap bet-
ween the tyres and drive rollers
The position indicator is no longer showing a num-
•
ber (Fig. 30)�
 The manoeuvring system can also be disengaged
manually if the power supply of the manoeuvring
system is interrupted or if a malfunction prevents au-
tomatic disengagement� See Kapitel 5�7 Emergency
disengagement�
5.7 Disengage the manoeuvring
system manually (emergency
disengagement)

CAUTION
Personal injury due to the caravan rolling
away
If the drive rollers are disengaged, the caravan
cannot be controlled�
Before the disengagement, apply the
caravan's parking brake and secure with
wedges�
38 EN

NOTICE
Damage due to an incorrect tool
The manoeuvring system must only be disen-
gaged manually� Other auxiliary equipment, e�g�
cordless screwdrivers, can damage the mano-
euvring system�
If the caravan battery is discharged to the extent that
electrical disengagement no longer works or a defect
is present, the drive rollers can also be disengaged
manually�
Mover
Fig. 31
Before manual disengagement, apply the caravan's
parking brake and secure the wheels against rolling
Mover
away�
Disconnect the power supply for the manoeuvring
system using the battery cut-off switch�
Prise out the plastic cap (Fig. 31-1) at the rear end of
the cover using a screwdriver�
Insert the hexagonal socket spanner – included in
the scope of delivery – into the hex bolt (Fig. 31-2)
and carefully disengage the drive unit by turning in a
clockwise direction (Fig. 31-3)�
Repeat the procedure for all drive units�
Use the supplied hexagonal socket spanner�
60020-00214 ∙ 00 ∙ 08/2022
Mover XT L
3
2
1