Truma Mover XT L Gebrauchsanweisung Seite 31

Mover XT L
Sym- Display
bol
Rapid flashing
with acoustic
signals
Sym- Display
bol
Switch off, usual process
Goes out
Switch off, special process
Flashes with
acoustic signal
Lights up
Flashes with
acoustic signal
Lights up
Flashing with
acoustic signal
60020-00214 ∙ 00 ∙ 08/2022
Meaning
The remote control is swit-
ched off after a while� The
warning symbol means
that the drive rollers are
still engaged
Meaning
The remote control was
switched off while the
control unit was still in
operation and the drive
rollers were disengaged�
Afterwards, the control
unit should be switched
off and the 13-pole safety
plug should be pulled out�
Warning that the drive
rollers are still engaged
while the remote control is
switching off� The remote
control switches off after
a short time� Switch the
remote control back on
again, disengage the drive
rollers and switch off the
remote control again�
The control unit was swit-
ched off while the remote
control was switched on�
The drive rollers were di-
sengaged during this pro-
cess� The remote control
switches off after a short
time� Move the remote
control's slide switch into
the Off position�
The control unit was swit-
ched off while the remote
control was switched on�
Warning: The drive rollers
were engaged during this
process�
The remote control swit-
ches off after a while�
Switch the control unit
and the remote control
back on again, disenga-
ge the drive rollers and
switch off normally�
Sym- Display
bol
Flashing with
acoustic signal
Flashes with
acoustic signals
Sym- Display
bol
What to do if the battery is weak or if overcurrent /
overtemperature / other malfunctions occur
Lights up
Light up if sym-
bols appear
Lights up con-
tinuously with
acoustic signal
XT-Reihe
All symbols "off" and no acoustic signal
Product description
Meaning
The 13-pole safety plug
was pulled out while the
remote control was swit-
ched on�
Warning: The drive rollers
were engaged during this
process�
Switch the control unit
back on again by plugging
in the safety plug, switch
the remote control off and
back on again, disenga-
ge the drive rollers and
switch off normally�
The 13-pole safety plug
was pulled out while the
remote control was swit-
ched on�
The drive rollers were di-
sengaged during this pro-
cess� The remote control
switches off after a short
time� Move the remote
control's slide switch into
the OFF position�
Meaning
lights up in the event of
a temporary malfunction,
and an acoustic signal is
also emitted in the event
of overcurrent / overtem-
perature� The power is au-
tomatically reduced� Allow
the system to cool down�
The battery charge is low,
the remote control swit-
ches off after one minute
with acoustic signals�
Charge the battery, re-
place it if necessary after
checking it
lights up in the event of
a persistent fault, and an
acoustic signal is also
emitted, e�g� in the event
of a faulty drive motor,
engage the parking bra-
ke� See the Malfunctions
chapter
EN 31