Charging The Product - Silvercrest SSRA1 Kurzanleitung

Set-up

Charging the product

Fully charge the product before using it for the
first time.
It takes approx. 5 to 6 hours to charge. The charging
process is also indicated in the display
Set up the charging dock
mains lead .
4
Place the charging dock
Note: Keep 1 m from the left / right and 2 m
from the front clear.
Note: Do not place the charging dock
near stairs.
Switch on the power switch
ing the product (Position "–"). The product will
light up when charging, even when the power
switch is set to position "O".
9
Place the product in the charging dock
position it according to the charging contacts
You can alternatively directly connect the mains
lead to the charging socket
4
Note: The product sometimes corrects its posi-
tion in the charging dock.
"Start / Pause" button
flashing orange: charging
green: fully charged
off: Sleep mode
Operation
26 GB/IE
.
1
and connect the
2
flush against a wall.
2
2
before charg-
9
and
2
.
3
on the product.
10
12
Note: The area around the charging dock
not have mirrors or other highly reflective objects
within 15 cm of the floor. If necessary, cover these.
CAUTION! Keep the charging dock
direct sunlight.
CAUTION! Change the position of the charging
dock as little as possible.
2
Attaching the side brushes
Install the side brushes
colour, pushing the brushes onto the colour pins.
Verify the side brushes
Switch the product on / off
Press the power switch
product. "–" is on, "O" is off. If the "Start /
Pause" button lights up green, the product
12
was successfully switched on.
Note: Do not switch off the product after use. Keep
the product in the charging dock
ready for the next vacuuming.
Note: Pressing the power switch
date, time and vacuuming schedule.
must
2
out of
2
according to the slot
20
are secure.
20
on the side of the
9
so it will be
2
will erase the
9