Set-Up; Charging The Product; Attaching The Side Brushes; Switch The Product On / Off - Silvercrest SSRA1 Bedienungs- Und Sicherheitshinweise

Do not mix used and new batter-
ies / rechargeable batteries.
Remove batteries / rechargeable
batteries if the product will not
be used for a longer period.
Risk of damage of the product
Only use the specified type of
battery / rechargeable battery!
Insert batteries / rechargeable
batteries according to polarity
marks (+) and (-) on the battery /
rechargeable battery and the
product.
Clean the contacts on the battery /
rechargeable battery and in the
battery compartment before in-
serting!
Remove exhausted batteries /
rechargeable batteries from the
product immediately.
Robot vacuum cleaner only
This product features a built-in
rechargeable battery which can-
not be replaced by the user. The
rechargeable battery must be
removed or replaced by the ma-
nufacturer or their service centre
or a similarly qualified person to
avoid hazards. When disposing
of the product, you must indicate
this product contains a rechar-
geable battery.

Set-up

Charging the product

Fully charge the product before using it for the first
time.
It takes approx. 5 to 6 hours to charge. The charg-
ing process is also indicated in the display
Set up the charging dock
mains lead .
4
Place the charging dock
Note: Keep 1 m from the left / right and 2 m
from the front clear.
Switch on the power switch
ing the product (Position "–").
Place the product in the charging dock
position it according to the charging contacts
You can alternatively directly connect the mains
lead to the charging socket
4
"Start / Pause" button
orange: charging
green: fully charged
off: Sleep mode
Note: The area around the charging dock
not have mirrors or other highly reflective objects
within 15 cm of the floor. If necessary, cover these.
CAUTION! Keep the charging dock
direct sunlight.
CAUTION! Change the position of the charging
dock as little as possible.
2

Attaching the side brushes

Install the side brushes
colour, pushing the brushes onto the colour pins.
Verify the side brushes
Switch the product on / off
Press the power switch
product. "–" is on, "O" is off. If the "Start /
Pause" button lights up the product is on.
13
Safety notes / Set-up
.
1
and connect the
2
flush against a wall.
2
before charg-
10
and
2
on the product.
11
13
must
2
out of
2
according to the slot
21
are secure.
21
on the side of the
10
GB/MT
.
3
95