Troubleshooting - Keimling Naturkost Soyabella SB-130 Bedienungsanleitung

Soyabella™ SB-130

Troubleshooting

Problem
Screen slips off head unit
Ingredients not
fully ground
Overfl ow
Alarm doesn't sound
Milk scorches
Milk too thin
Heating, but motor
not operating
Doesn't activate when
buttons are pushed
Probable Cause
Improperly fi tted over threads
Too much or too little in screen
Not enough water in the chamber
Basket screen clogged
Too much water in the chamber
Screen is clogged
Water level too low
Water temperature too cold
Blade shaft or overfl ow sensor is dirty
Not enough ingredients in screen
Too much ingredients, too little water
Screen clogged
Not enough ingredients
Ingredients not soaked
long enough
Check for clogs and operating errors
Water entered inside
of head unit
Solution
Re-secure screen by twisting it into the
proper lock direction.
Refi ll screen to recommended amount.
Fill chamber to a level between
the two inscribed marks.
Clean with the cleaning brush.
Adjust water level to within the two
inscribed marks.
Clean with the cleaning brush and hot,
soapy water.
Fill chamber to a level within the two
inscribed marks.
Warm water to 10° C - 40° C
(50° F - 104° F).
Clean thoroughly.
Try again – use the measuring
cup when fi lling the screen.
Try again – fi ll water in between
recommended fi ll lines. Use the measuring
cup when fi lling the screen.
Clean with the cleaning brush
and hot, soapy water.
Try again – use the measuring
cup when fi lling the screen.
Refer to suggestions in
operating instructions.
Power off and restart. Refer to
manual for operating instructions.
Wait 4-5 days for head unit to dry.
Then try again.
37