Making Soymilk, Nutmilks, Or Rice Milk - Keimling Naturkost Soyabella SB-130 Bedienungsanleitung

Soyabella™ SB-130
Operating Instructions
B.

Making Soymilk, Nutmilks, or Rice Milk

1. Soak soybeans
Use the measuring cup and take a full
cup of dry soybeans (2.5oz – 3.5oz., 70g
– 95g). Rinse soybeans thoroughly and
leave to soak for 4-6 hours or overnight.
TIP: When soaking the beans, put beans
directly into the milk screen and place the-
screen into the utility cup. Pour water into
the utility cup to soak the beans and let it
sit.
2. Add water to the stainless steel
chamber Fill the stainless-steel chamber
with water so that water level is between
the upper and lower water-level lines. You
can control the consistency of the soy-
bean milk by adding more or less water.
You may add warm water to shorten the
processing time. However, do not add
water over 104°F (40ºC).
3. Load soybeans and attach the
milk screen to the head unit
Drain the soybeans and load them into the
milk screen. Attach the milk screen to the
head unit by moving the blade in a side-
to-side motion to allow the screen to slide
properly into place. Caution: the grinding
blade is sharp! Lock the milk screen by tur-
ning it. The markings on the milk screen indi-
cate the proper lock and unlock directions.
Caution: Be sure the milk screen is pro-
perly locked in place! If the screen becomes
loose during operation, the spinning blade
could damage the screen.
30
4. Assemble machine and
run MILK function
Connect the head unit to the stainless steel
chamber. Make sure the upper plug slides
into the upper plug receptacle on top of
the handle. Plug the power cord into the
power plug receptacle, and connect the
other end to a wall socket. Soyabella will
beep and a red light will fl ash. Press the
"MILK" button on the program pad, and the
red light will turn solid. The cycle will take
approximately 15 minutes. When fi nished,
the indicator light will blink green, and the
machine will beep.
5. Pour milk and enjoy
Unplug the base unit. Lift the head unit
from the stainless steel chamber. When
removing the head unit, do not touch the
screen, as it will be hot. Make sure that all
milk drains from the screen before moving
the head unit away from the stainless steel
chamber. Place the head unit with the
screen still attached into the utility cup to
cool, making sure that the handle under the
steel screen fi ts within the corresponding
groove in the plastic utility cup. Carefully
pour milk from the stainless steel chamber.
Caution:
Soymilk
Allow milk to cool before serving.
TIP:
Add your
ents to fl avour
a pinch of sea salt, or brown sugar,
vanilla - any other fl avours you like.
Please note: to avoid protein build-up,
clean the milk screen as soon as possible
(see p. 36 for cleaning instructions).
will be hot.
favourite ingredi-
your soymilk. Add