Making Raw Nut Milks - Keimling Naturkost Soyabella SB-130 Bedienungsanleitung

Soyabella™ SB-130
Operating Instructions
C.

Making Raw Nut Milks

1. Soak nuts
Use the measuring cup and take a full cup
of dry nuts. Rinse thoroughly and leave to
soak overnight, or for at least 4 hours.
TIP: When soaking the nuts, put them
directly into the milk screen and place the-
screen into the utility cup. Pour water into
the utility cup to soak the beans and let it sit.
TIP: Soyabella will work fi ne even if you
do not soak the nuts. However, we always
recommend soaking nuts and beans
before making milks in order to maximize
health benefi ts.
2. Add water to the
stainless steel chamber
Fill the stainless-steel chamber with water
so that the water level is between the
upper and lower water-level lines.
3. Load nuts and attach
milk screen to the head unit
Load nuts into the milk screen. You
may add a little bit more soaked nuts
if you want thicker milk. Attach the milk
screen to the head unit by moving the
blade in a side-to-side motion to allow
the screen to slide properly into place.
Caution: the grinding blade is sharp!
Lock the milk screen by turning it. The
markings on the milk screen indicate
the proper lock and unlock directions.
Caution: Be sure the milk screen is
properly locked in place! If the screen
becomes loose during operation, the
spinning blade could damage the screen.
4. Assemble machine
and run MILL function
Connect the head unit to the stainless steel
chamber. Make sure the upper plug slides
into the upper plug receptacle on top of
the handle. Plug the power cord into the
power plug receptacle, and connect the
other end to a wall socket. Soyabella will
beep and a red light will fl ash. Press the
MILL button on the program pad, the red
light will turn solid, and Soyabella will run
through a 10 second grinding cycle. After
about 3 seconds, the red light will fl ash.
Repeat this procedure several times depen-
ding on how thick you want the milk.
5. Pour milk and enjoy
Unplug the base unit. Lift the head unit
with the screen from the stainless steel
chamber. Make sure that all the milk drains
from the screen before moving the head
unit away from the stainless steel chamber.
Place the head unit with the screen still
attached into the utility cup. Carefully pour
milk from the stainless steel chamber.
TIP: Add your favourite ingredients to fl a-
vour your soymilk. Add a pinch of sea salt,
whole cane sugar, honey, agave nectar,
or vanilla – any other fl avours you like.
Please note: to avoid protein build-up,
clean the milk screen as soon as possible
(see p. 36 for cleaning instructions).
31